Line size adapter
Posted: Wed May 28, 2025 3:16 pm
Hey there,
So in my last ditch quest to get this Suzuki Samurai AC to blow cold I replaced the condenser with a parallel flow unit with no 8 and 6 fittings.I ran a new no 6 hard line to the new drier ( no 6 in and out) but on the drier out port I need to step down to the factory 9/16-18 hard line fitting running from the evaporator. Is there an adapter to step up the 9/16-18 male o ring fitting up to no 6 male ( drier port) ?
I cannot find any supplier that even lists any kind of 9/16 fittings.Hey there,
So in my last ditch quest to get this Suzuki Samurai AC to blow cold I replaced the condenser with a parallel flow unit with no 8 and 6 fittings.I ran a new no 6 hard line to the new drier ( no 6 in and out) but on the drier out port I need to step down to the factory 9/16-18 hard line fitting running from the evaporator. Is there an adapter to step up the 9/16-18 female o ring fitting up to no 6 male ( drier port) ?
I cannot find any supplier that even lists any kind of 9/16 fittings.
So in my last ditch quest to get this Suzuki Samurai AC to blow cold I replaced the condenser with a parallel flow unit with no 8 and 6 fittings.I ran a new no 6 hard line to the new drier ( no 6 in and out) but on the drier out port I need to step down to the factory 9/16-18 hard line fitting running from the evaporator. Is there an adapter to step up the 9/16-18 male o ring fitting up to no 6 male ( drier port) ?
I cannot find any supplier that even lists any kind of 9/16 fittings.Hey there,
So in my last ditch quest to get this Suzuki Samurai AC to blow cold I replaced the condenser with a parallel flow unit with no 8 and 6 fittings.I ran a new no 6 hard line to the new drier ( no 6 in and out) but on the drier out port I need to step down to the factory 9/16-18 hard line fitting running from the evaporator. Is there an adapter to step up the 9/16-18 female o ring fitting up to no 6 male ( drier port) ?
I cannot find any supplier that even lists any kind of 9/16 fittings.